Canon i-SENSYS MF8550Cdn - Manual (Page 8)

8
En
8
Enter the network key.
1 Enter the network key using the numeric keys.
2 Press [OK].
9
Select <Yes>, and then press [OK].
10
After the <Connected.> screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on.
Wait approximately 2 minutes after the
connection.
IP address is set during this period of time.
When an error message appears:
Press [OK] to close the screen, check whether or not
the network key is correct, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
e-Manual "When an Error Message Appears"
To set IP address manually:
e-Manual "Setting IP Addresses"
Checking That the Wireless LAN Setting
is Completed
1
Press (Status Monitor).
2
Select <Network Information>, and then press
[OK].
3
Select <IPv4>, and then press [OK].
4
Select <IP Address>, and then press [OK].
5
Take note of the IP address.
6
Press (Status Monitor).
7
Start a Web browser from a computer, enter
"http://<IP address of the machine>/" in the
address field, and then press [Enter] on your
keyboard.
8
Check that the screen of the Remote UI is
displayed.
Connection is completed if the screen is displayed.
If the screen is not displayed correctly:
e-Manual "Common Problems"