Canon LV-7392A - Manual (Page 59)

Setting
59
Setting
Remote control This projector provides two different remote
control codes: the factory-set initial code
( Code 1) and the secondary code (Code 2).
This switching function prevents remote control
unit interference when operating several
projectors or video equipment at the same
time.
When operating the projector in Code 2, both
the projector and the remote control unit must
be switched to Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting
Menu.
To change the code for the remote control
unit:
Press and hold both the MENU and IMAGE
buttons together for 5 seconds or more. After
changing the code, make sure the remote
control unit operates properly.

Note:
• When different codes are set on the projector
and on the remote control unit, any operation
cannot be made. In that case, switch the code
on the remote control unit to fit the code on the
projector.
• If the batteries are removed from the remote
control unit for a long period of time, the remote
control code will be reset.
Remote control
This function allows you to change brightness
of the screen.
Lamp mode
 Note:
• Lamp mode can not be changed for a
while after turning on the projector. Lamp
needs some time to stabilize after the
power is turned on. Stored lamp mode will
be active after the lamp is stabilized.
High ........... Brighter than the Normal
mode.
Normal ...... Normal brightness
Eco ............ Lower brightness reduces the
lamp power consumption and
extends the lamp life.