Altinex Dual Twisted Pair Receiver to Computer / Component Video + Audio MT115-111 - Manual (Page 12)

MULTITASKER
400-0443-004 11
2. [C]
This command receives the status of the card.
Command Format: [Cn]
Cn = Card ID (n = # from 1 to max slots)
Example:
There is one MT115-111 card in slot 4. Sending
the command [C4] to the system will yield
feedback similar to the following:
INPUT#1 VIDEO GAIN 4
EQUALIZATION 32
INPUT#2 VIDEO GAIN 4
EQUALIZATION 32
In this case, both card inputs are set for a video
gain of 4 and an equalization of 32.
If there is no card in slot 4, sending the [C4]
command will not return any feedback.
3. [CnS]
This command saves the card settings and
displays the status. After the system is reset or
powered off and on, the settings are restored.
Cn = card number
S = save configuration
Example:
Save the status by sending [C4S]. The
feedback returned will be similar to the following:
INPUT#1 VIDEO GAIN 4
EQUALIZATION 32
INPUT#2 VIDEO GAIN 4
EQUALIZATION 32
SAVED
4. [...S]
This command will save the configuration
command being sent in memory. When sending
the command [EQ1=16C4S], after reset or
power up, the equalization for Input 1 will be set
to 16.
5. [CLR]
This command clears the card settings and
returns it to the factory default values. The
defaults gain setting is 4 and the default
equalization setting is 32 for each input.
Command Format: [CLRCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
In order to clear the card in slot 4, send the
command [CLRC4]. The card will respond with
the following feedback when complete:
FACTORY RESET COMPLETED
6. [TEST]
This command performs a series of tests on the
internal memory and displays a pass message if
successful. Otherwise, failures are indicated.
Command Format: [TESTCn]
Cn = Card ID (n = slot # from 1 to max slots)
Upon completion, the system will display the
results. This feedback will be similar to the
following:
MEMORY IC TEST RESULTS:
MEMORY IC PASS
7. [HELP]
This command displays information available for
the MultiTasker interface commands.
Command Format: [HELPCn]
Cn = Card ID (n = # from 1 to max slots)
Example:
In order to display the RS-232 commands
available for the MT115-111 card in slot 4, send
the command [HELPC4]. The commands along
with a brief description will be displayed in the
Terminal Window.