Canon Macro Twin Lite MT-24EX - Manual (Page 20)

18
1 Turn on the power switch.
Set the power switch to <K> or
<g>.
X The flash recycling starts.
2 Check that the flash is ready.
The pilot lamp will light in red (fully
charged) when the flash is ready.
X Pressing the pilot lamp will fire a test
flash.
Turning on the Power Switch
To save battery power, the <g> Save Energy feature automatically turns off
the MR-14EX/MT-24EX after 90 sec. of non-operation. To turn on the MR-
14EX/MT-24EX again, press the camera’s shutter button halfway.
A test firing cannot be fired while the camera’s operation timer 4 or 0
is active.
The MR-14EX/MT-24EX’s settings will be retained in memory even after
the power is turned off. To retain the MR-14EX/MT-24EX’s settings when
you replace the batteries, replace the batteries within 1 minute after
turning off the power.
When the camera’s shooting mode is set to <V> (Program AE) or <U> (Full
Auto), E-TTL II/E-TTL fully automatic flash photography will be enabled, making
it as easy as normal AE shooting in the <V> or <U> mode.
1 Set the MR-14EX/MT-24EX to <ETTL>.
Press the <D> button to
display <a>.
2 Take the picture.
Focus the picture and check that the
<Q> icon is lit in the viewfinder.
X If a standard flash exposure was
obtained, the flash exposure confirmation
lamp will light for about 3 sec.
Fully Automatic Flash Shooting
MR14_MT24_02.fm Page 18 Saturday, January 23, 2010 10:45 AM
COP
Y