C op y – Canon PowerShot D20 User Manual
Page 195
Troubleshooting
195
is displayed when the shutter button is pressed halfway (p. 65).
•
Set [IS mode] to [Continuous] (p. 119).
•
Set the flash mode to
•
Increase the ISO speed (p. 102).
•
Mount the camera on a tripod or take other measures to keep it still. In this case, set [IS
Mode] to [Off] (p. 119).
Shots are out of focus.
•
Press the shutter button halfway to focus on subjects before pressing it all the way down
to shoot (p. 39).
•
Make sure subjects are within focusing range (see “Specifications” in the Getting
Started guide).
•
Set [AF-assist Beam] to [On] (p. 75).
•
Confirm that unneeded functions such as macro are deactivated.
•
Try shooting with focus lock or AF lock (pp. 113, 116).
No AF frames are displayed and the camera does not focus when the shutter
button is pressed halfway.
•
To have AF frames displayed and the camera focus correctly, try composing the shot
with higher-contrast subject areas centered before you press the shutter button
halfway. Otherwise, try pressing the shutter button halfway repeatedly.
Subjects in shots look too dark.
•
Set the flash mode to
•
Adjust brightness by using exposure compensation (p. 101).
•
Adjust contrast by using i-Contrast (pp. 103, 149).
•
Use spot metering or AE lock (pp. 101, 102).
Subjects look too bright, highlights are washed-out.
•
Set the flash mode to
! (p. 65).
•
Adjust brightness by using exposure compensation (p. 101).
•
Use spot metering or AE lock (pp. 101, 102).
•
Reduce the lighting on subjects.
Shots look too dark despite the flash firing (p. 57).
•
Shoot within flash range (p. 117).
•
Increase the ISO speed (p. 102).
Subjects in flash shots look too bright, highlights are washed-out.
•
Shoot within flash range (p. 117).
•
Set the flash mode to
! (p. 65).
White dots or similar image artifacts appear in flash shots.
•
This is caused by light from the flash reflecting off dust or airborne particles.
Shots look grainy.
•
Lower the ISO speed (p. 102).
Y