Canon CR-2 - Manual (Page 22)

22
4 Basic Operations
Connecting Cables
Connect the CR-2 to a computer in which the supplied software, the Rics NM 2, has been installed.
WARNING
• Do not plug or unplug the power plug with wet hands.
• Do not use any power cord other than the one supplied.
Otherwise, fire or electric shock may result.
1
Make sure that the power switch for the CR-2 is turned off.
2
Connect the power cord and the USB cable to the
retinal camera.
3
Insert the power plug all the way into an AC outlet.
4
Connect the other end of the USB cable to the USB connector of the PC.
Use a high-speed AB type USB cable that is shorter than three meters. For details, contact your
sales representative or local Canon dealer.
Preparing for an Examination
CAUTION
• To prevent the risk of infection, wipe the forehead rest with disinfectant ethanol for each patient.
For details on how to disinfect, consult a specialist.
• To ensure cleanliness, replace the chin rest paper for each patient.
1
Turn on the computer and start the Rics NM 2.
2
If the digital camera is off, turn the switch to the ON.
If the Mode Dial is set to anything other than , an image cannot be taken.
While holding down the button at the center of the Mode Dial, turn the dial to .