Canon imagePROGRAF iPF8400 - Manual (Page 134)

Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print
sheet or other printer status information.)
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
"Replace roll with 10 in. wide or larger roll."
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet or other
printer status information.) Replace the roll with a roll 10 inches in width or larger as follows.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
→P.15
(See "Removing the Roll Holder from Rolls.") →User's Guide
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Attaching the Roll Holder to Rolls.")
→P.9
(See "Loading Rolls in the Printer.") →P.11
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver. Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
→P.15
(See "Removing the Roll Holder from Rolls.") →User's Guide
2.
Replace with paper of the width configured in the printer driver.
(See "Attaching the Roll Holder to Rolls.")
→P.9
(See "Loading Rolls in the Printer.") →P.11
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded in
the printer, and then try printing again.
Paper size not detected. Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload the pa-
per.
(See "Loading Rolls in the Printer.")
→P.11
(See "Loading Sheets in the Printer.")
→P.18
If "Not finished printing. Finish printing
remaining jobs?" is displayed on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
PaprWidth Mismatch iPF8400
Basic Guide
Error Message
Messages regarding paper
134