Audiovox ACC-52 - Manual (Page 11)

CAR ANTENNA INPUT
Locate your existing car radio antenna cable. This is
normally a black cable about as thick as a pencil and
will be plugged into a socket on the rear of your car
radio. Unplug this antenna lead and plug it into the
mating female socket on the FM module.
IMPORTANT - Some Import cars have a special dual
antenna called “DIVERSITY ANTENNA”. If your car
has this type of antenna system, you will find the
antenna cable will not fit the socket on the FM module.
Use of the ACC-52 with “DIVERSITY ANTENNA" is
not recommended. You may also find some late model
GM cars have an antenna plug that is too small to mate
with the FM module. If this is found, call Audiovox’s
Toll-Free Assistance for a special adaptor. This adap-
tor can also be purchased at any car stereo installation
center.
RADIO ANTENNA OUTPUT
Attached to the FM module is a male antenna plug.
Simply plug this into the socket on the car radio from
which you just removed the car antenna cable.
REMOTE CONTROL CABLE
Attached to your remote control is a cable that plugs
into the remaining socket on the end of the FM module.
Position the remote control near the area you will
permanently mount it and route the cable to the FM
module. Plug the cable into the FM module.
WIRING THE FM MODULE (con't.)
BLACK GROUND WIRE
The 3 foot black wire attached to the FM module
must be secured to a grounded metal part of the
car’s chassis. If you cannot find an existing bolt or
screw to fasten it to, you must drill a hole in the metal
and secure it with a screw. To insure a good ground,
remove any paint or grease where the wire will
connect.
BLACK GROUND WIRE
EXISTING
SCREW
OR BOLT
GROUNDED METAL PART
OF CHASSIS
FM MODULE
FM MODULE
CAR RADIO
FEMALE CONNECTOR
FM MODULE
EXISTING CAR ANTENNA
EXISTING CAR RADIO
(UNPLUG ANTENNA CABLE)
REMOTE CONTROL
CAR ANTENNA CABLE
REMOTE CONTROL CABLE
MALE ANTENNA PLUG
FM MODULE
MALE ANTENNA PLUG
11