Audiovox PRO 9232S - Manual (Page 4)

USING THE VALET SWITCH:
The valet switch allows you to temporarily bypass all alarm functions, eliminat-
ing the need to hand your transmitter to parking attendants or garage mechan-
ics. When the system is in valet mode, all alarm functions are bypassed, how-
ever the remote panic feature and remote door locks will remain operational. To
use the valet mode, the system must first be disarmed either by using your
keychain transmitter, or by activating your personalized manual override code.
TO ENTER THE VALET MODE:
1. Disarm the unit by use of the factory transmitter or by use of the
manual override sequence.
2. Turn the ignition switch to the “On” position.
3. Press and hold the valet/override pushbutton switch for 5 seconds.
The LED turns on, indicating valet mode has been successfully
entered.
TO EXIT THE VALET MODE:
With the ignition switch in the on position, press and release the valet/override
pushbutton switch one time. The LED turns off indicating the valet mode has
successfully been exited.
MANUAL OVERRIDE OPERATION:
If your factory transmitter is lost, broken, or otherwise rendered inoperable, your
system can be overriden allowing operation of the vehicle. The manual
override code is pre-programmed at the factory to 11. This code can be
changed by the operator to a more familar two digit number. Once you’ve
become familiar with the system’s operation and override proceedure, we
suggest you change the code for added security.
NOTE: The override proceedure below describes use, assuming that the
factory pre-set code has not been been changed and is still set to the
factory default 11. The valet/override push button switch is used to
enter the tenths and units digits, pressing and releasing this button
one time for each digit required.
To manually overrride your system,with a code of 11, follow the sequence listed
below:
1. The LED is flashing indicating unit is armed, enter the vehicle, the
siren will sound, turn the ignition switch to the “on” position.
2. Within 10 seconds begin to enter tenths digit of override code. (In this
example the code is 11, so press and release the Valet/Override
pushbutton one time).
3. Within 10 seconds of entering the last tenths digit, turn ignition “off
then on”.