Electrolux ESL6361LO - Manual (Page 10)

7. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to ’Set-
ting and starting a programme’.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
• If you use the combi detergent tab-
lets, activate the multitab option.
5. Set and start the correct programme
for the type of load and the degree of
soil.
7.1 Using the detergent
A B D
30
20
C
M AX
1 2 3 4
+ -
B
2 0 0 3
A D
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance a few minutes after:
• You have not closed the door to start
the programme.
• The programme is completed.
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
The appliance is in setting mode when,
after the activation, the indicator of
is on and the display shows the duration
of the programme.
If the control panel does not show this
condition, press and hold, at the same
time
and until the indi-
cator of comes on.
10 www.electrolux.com