Electrolux EHL7640FOK - Manual (Page 30)

lowest temperatures and do not brown
food too much.
6. CARE AND CLEANING
Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the
glass-ceramic cause no effect on
how the appliance operates.
To remove the dirt:
1. – Remove immediately: melted
plastic, plastic foil, and food with
sugar. If not, the dirt can cause
damage to the appliance. Use a
special scraper for the glass . Put
the scraper on the glass surface at
an acute angle and move the blade
on the surface .
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metal-
lic discolorations. Use a special
cleaning agent for glass ceramic or
stainless steel.
2. Clean the appliance with a moist cloth
and some detergent.
3. At the end rub the appliance dry
with a clean cloth.
7. TROUBLESHOOTING
Problem Possible Remedy
You cannot activate the
appliance or operate it. Activate the appliance
again and set the heat
setting in less than 10
seconds.
You touched 2 or more
sensor fields at the same
time. Touch only one sensor
field.
The STOP+GO function
operates. Refer to the chapter “Dai-
ly Use”.
There is water or fat
stains on the control pan-
el. Clean the control panel.
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated. You put something on
one or more sensor fields. Remove the object from
the sensor fields.
The appliance deacti-
vates. You put something on the
sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not come on. The cooking zone is not
hot because it operated
only for a short time. If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
30 www.electrolux.com