Electrolux EQT4520BOG - Manual (Page 32)

Problem Possible cause Remedy
Activate the appliance
again and set the heat
setting in less than 7 sec-
onds.
You touched 2 or more
sensor fields at the same
time. Touch only one sensor
field.
There is water or fat
stains on the control pan-
el. Clean the control panel.
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated. You put something on
one or more sensor fields. Remove the object from
the sensor fields.
The appliance deacti-
vates. You put something on the
sensor field
.
Remove the object from
the sensor field.
The residual heat indica-
tor does not come on. The roasting zone is not
hot because it operated
only for a short time. If the roasting zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
There is no signal when
you touch the panel sen-
sor fields. The signals are deactiva-
ted. Activate the signals (refer
to “OffSound Control”).
comes on The Automatic Switch Off
operates. Deactivate the appliance
and activate it again.
comes on The Child Safety Device
or the Lock function op-
erates. Refer to the chapter “Dai-
ly Use”.
and number come on. There is an error in the
appliance. Disconnect the fuse from
the electrical system of
the house in order to dis-
connect the appliance
from the electrical supply
for some time. Connect it
again. If
comes on
again, speak to the serv-
ice centre.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the Customer Care Department.
Give the data from the rating plate, three-
digit-letter code for the glass ceramic (it is
in the corner of the cooking surface) and
an error message that comes on. If you operated the appliance incorrectly,
the servicing by a customer service tech-
nician or dealer will not be free of charge,
even during the warranty period. The in-
structions about the customer service and
conditions of guarantee are in the guaran-
tee booklet.
32 www.electrolux.com