Bosch SGE63E06UC - Manual (Page 11)

11
The unit should now be ready to slide into the cabinet
opening. To avoid scratching the loor, use loor protection and
caution when sliding the dishwasher into the cabinet. Make
sure that the hoses and cords do not bunch up behind the
unit or kink as you slide the unit back. Make certain to slide
the unit into place before raising the leg levelers.
Level the dishwasher horizontally by turning feet clockwise
to raise or counter-clockwise to lower front of the unit.
Level the dishwasher vertically by turning center screw to
raise or lower the back.
1. Drive the mounting screws through the holes in the
mounting brackets as shown for Top or Side Mount.
2. After the unit is installed in the enclosure, leveled and
secured, lock the two front leg levelers in place by driving
the enclosed leg leveler locking screws into each screw
boss located in front of the levelers. See Figure 18.
3. Tighten screws until they are lush with the surface of the
bosses.
LEVELING THE DISHWASHER
SECURING THE DISHWASHER
For Top Mount - Wooden
For Side Mount - Stone Countertop
Avoid Tip Over Hazard
Do not use the dishwasher until it is completely
installed. When opening the door on an uninstalled
dishwasher, carefully open the door while
supporting the rear of the unit. Failure to follow
this warning can result in serious injury.
WARNING
Figure 16
Figure 17
Figure 18
0
-
2
.5
“
mm/
0
.5
” mm/ 0.1”
mm/
0
.1
”
mm/ 0.5”