Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 19)

NetWare
Manual No. 775079 2-5
2
N
E
T
W
A
R
E
3. Choose “Configure disk and storage device drivers” in the Driver
Options menu.
4. Choose “Select an additional driver” in the Additional Driver Actions
menu.
NetWare scans for controllers that do not have drivers already loaded.
5. At the “Select a driver” box, press <Ins> to choose to install an
unlisted driver.
6. Insert the DOS-formatted NT4/NW Drivers Software Kit diskette into
the diskette drive.
7. Press <F3> to specify the path of the NetWare driver you’re about to
install.
8. Change the path line to read:
A:\netware
and press <Enter>. NetWare scans for drivers on the floppy diskette in
the specified path.
9. In the “Select a driver to install” box, select the appropriate driver for
your controller:
MDAC.HAM | <Controller model number>
10. Select Yes at the confirmation box to install the driver.
11. Press <Enter> to select the default server boot path.
12. Select Yes to save a backup of the old or existing driver.
13. Press <Enter> to continue when you see the message that the old
driver will be saved.
NetWare copies the file.
14. What you just backed up was the old or existing .DSK or .HAM file.
Repeat Steps 12 and 13 for the .DDI file.
15. Select No to decline selection of an additional driver to install unless
you are installing more than one Mylex controller at this time.
16. Exit INSTALL.NLM by pressing <Esc> three times, then selecting Yes
at the “Exit Install?” box.
This concludes installation of the driver files needed to run your Mylex Disk
Array Controller under NetWare 4.2.