Acer PCI Disk Array Controller Drivers 08P4100 - Manual (Page 24)

Installing the Mylex Disk Array Controller as the Primary NetWare 5.0 Controller
2-10 PCI Disk Array Controller Drivers Manual
NetWare scans for controllers that do not have drivers already loaded.
6. At the “Select a driver” box, press <Ins> to choose to install an
unlisted driver.
7. Insert the NT4/NW Drivers Software Kit diskette into the diskette
drive.
8. Press <F3> to specify the path of the NetWare driver you’re about to
install.
9. Change the path line to read:
A:\netware
and press <Enter>. NetWare scans for drivers on the floppy diskette in
the specified path.
10. In the “Select a driver to install” box, select the appropriate driver for
your controller:
MDAC.HAM | Mylex Disk Array Controller <model number>
11. Select Yes at the confirmation box to install the driver.
12. Press <Enter> to select the default server boot path.
13. Select No to save a backup of the old or existing driver.
14. Select No to decline selection of an additional driver to install unless
you are installing more than one controller at this time.
15. Exit INSTALL.NLM by pressing <Esc> three times, then selecting
Yes at the “Exit Install?” box.
This concludes installation of the driver files needed to run your Mylex Disk
Array Controller under NetWare 5.0.