Power – LG PA77U User Manual

Page 4

Advertising
background image

4

SAFETY INSTRUCTIONS

y

Do not place the projector close to
sources of steam or oil mist, such as
humidifiers and kitchen counters.
- Failure to do so may result in fire,

electric shock, or corrosion.

y

Do not install the product onto a wall
or ceiling that is close to sources of
steam or oil mist.
- The product may be damaged and

fall, resulting in serious injury.

y

Do not place the projector where it
might be exposed to dust.
- This may result in fire.

y

Do not use the projector in a damp
place such as a bathroom where it is
likely to get wet.
- This may result in fire or electric

shock.

y

Do not allow a tablecloth or curtain to
block the air vent.
- This may result in fire due to the

increase in the internal temperature.

y

Ensure good ventilation around the
projector. The distance between the
projector and the wall should be at
least 30 cm (11.8 inches).
- This will prevent fire due to the

increase in the internal temperature.

CAUTION

y

When placing the projector on a table
or shelf, be careful not to put it near
the edge.
- The projector could fall due to balance

problems, which may cause personal
injury or damage to the product. Make
sure to use the projector cabinet or
stand that fits the projector.

y

When moving the projector, make
sure to switch it off and remove the
power plug and cords.

- The power cord may be damaged,

resulting in fire or electric shock.

y

Do not place the projector on an
unstable or vibrating surface such as
a wobbly shelf or a slope.
- It may fall and cause injury.

y

Be careful not to tip the projector over
when connecting external devices to
the projector.
- This may cause personal injury or

damage to the projector.

Power

WARNING

y

The grounding wire should be con-
nected.
- Ensure that you connect the ground-

ing cable to avoid electric shock.
If it is not possible to ground the unit,
have a qualified electrician install a
separate circuit breaker.
Do not try to ground the projector
by connecting it to telephone wires,
lightning rods or gas pipes.

y

The power plug should be inserted
fully into the power outlet.
- An unstable connection may cause

a fire.

y

Do not place heavy objects on the
power cord.
- This may result in fire or electric

shock.

y

Never touch the power plug with wet
hands.
- This may result in electric shock.

y

Do not plug too many devices into
one multi-power outlet.
- This may result in fire due to the

power outlet overheating.

Advertising