LG 42LC4D - Manual (Page 19)

EXTERNAL
EQ
UIPMENT
SETUP
17
HD RECEIVER SETUP
EXTERNAL EQUIPMENT SETUP
This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you
do receive digital signals from a digital set-top box or other digital external device, refer to the figure as shown
below.
DIGITAL AUDIO
OUT
OPTICAL
A
V
OUT
A
V
IN 1
VIDEO AUDIO
MONO ( )
S-VIDEO
COMPONENT IN VIDEO AUDIO
Y L R P B P R
When connecting Component cable
1 2
1. How to connect
Connect the video outputs (Y, P B , P R
) of the digital set
top box to the C CO OM MPPO ON NEEN NT T IIN N V VIID DEEO O 1 1 jacks on
the set. Match the jack colors
(Y = green, P
B = blue, and P R = red).
Connect the audio output of the digital set-top box to
the C
CO OM MPPO ON NEEN NT T IIN N A AU UD DIIO O 1 1 jacks on the set.
2
1
2. How to use
■ Turn on the digital set-top box.
(Refer to the owner’s manual for the digital set-top box. operation)
■ Select C Co om mp po onneenntt 1 1 input source by using the IIN NPPU UT T
button on the remote control.
■ If connected to C CO OM MPPO ON NEEN NT T IIN N2 2 input, select
C Co om mp po onneenntt 2 2 input source.
Signal
480i
480p
720p
1080i
1080p
Component 1/2
Yes
Yes
Yes
Yes
Yes
HDMI1/DVI,
HDMI2
No
Yes
Yes
Yes
Yes
■ To prevent the equipment damage, never plug in any power cords until you have finished connecting all equipment.
■ This part of EXTERNAL EQUIPMENT SETUP mainly use picture for the 42 inches models.