H o w to u s e, Sorting wash loads, Leveling the washer – LG WM3988HWA User Manual

Page 9

Advertising
background image

3

I N S TA L L AT I O N I N S T RU C T I O N S

SORTING WASH LOADS

H O W TO U S E

LEVELING THE WASHER

Loosen the locknuts on all 4 leveling feet

until you can turn the feet with the included

wrench. Turn clockwise to raise the washer

or counterclockwise to lower it.

2

Once the washer is level from side to side

and front to back, tighten all locknuts

securely.
Make sure that all 4 leveling feet are in firm

contact with the floor.
NOTE: To make sure that the washer is

properly level, run the washer with a test

load: place approximately 6 pounds of

laundry in the machine. Then press POWER,

press RINSE+SPIN, and then press the

START/PAUSE button. See the following

sections for additional information on cycle

selection and operation.

Verify that the washer does not rock or

vibrate excessively during the spin cycle.

If the washer vibrates or shakes, adjust

the leveling feet until the washer is stable

and retest.

Fabric Care Labels

Most articles of clothing feature fabric care labels

that include instructions for proper care.

Grouping Similar Items

For best results, sort clothes into loads that can

be washed with the same wash cycle.
Different fabrics have different care requirements.
Always wash dark colors separately from light

colors and whites to prevent discoloration. If

possible, do not wash heavily soiled items with

lightly soiled ones. The chart below shows

recommended groupings.

Bleach

symbols

Any bleach

(when needed)

Only non-chlorine bleach

(when needed)

Do not bleach

Machine

wash

cycle

Normal Permanent press/

wrinkle resistant

Gentle/

delicate

Hand wash

Do not wash

Do not wring

Water

temperature

Hot

(50°C/120°F)

Warm

(40°C/105°F)

Cold/cool

(30°C/85°F)

Fabric Care Labels

Sort Laundry...

by Colors

by Soil

by Fabric

by Lint

Whites

Heavy

Delicates

Lint Producer

Lights

Normal

Easy Care

Lint Collector

Darks

Light

Sturdy

Loading the Washer

Check all pockets to make sure that they

are empty. Items such as clips, matches,

pens, coins, and keys can damage both your

washer and your clothes.

• Close zippers, hooks, and drawstrings to

prevent these items from snagging or tangling

on other clothes.

• Pretreat heavily stained areas for best results.
• Combine large and small items in a load. Load

large items first.

• Large items should not be more than half of the

total washload.

• The washer can be fully loaded, but the drum

should not be tightly packed with items. The

door of the washer should close easily.

• To prevent an out-of-balance load, do not wash

single items. Add one or two similar items to

the load. Large, bulky items, such as a blanket,

comforter, or bedspread should be washed

individually.

• Do not wash or spin waterproof clothes.
• When unloading the washer, check under the

door seal for small items.

Position the washer in the final location,

taking special care to not pinch, strain, or

crush the water and drain lines. Place a level

across the top of the washer.

1

Level

Leveling

Feet

Leveling

Feet

The drum of your new washer spins at very high

speeds, up to 1,320 RPM. To minimize vibration,

noise, and unwanted movement, the floor must

be a perfectly level, solid surface.
NOTE: Adjust the leveling feet only as far as

necessary to level the washer. Extending the

leveling feet more than necessary can cause

the washer to vibrate.
• All four leveling feet must rest solidly on the

floor. Rock the washer gently from corner to

corner to make sure that the washer does

not rock.

If you are installing the washer on the optional

pedestal, you must use the leveling feet on

the

pedestal to level the washer. The washer’s

leveling feet should be fully retracted and locked

into position with the locknuts.

Raise

Lower

Tighten all 4

locknuts securely

NOTE: The capacity of the machine for washing

clothes is twice as much as when drying clothes.

If the machine is to be used to dry a load, then

the wash load must be reduced by half for

effective drying performance. If a full load is

washed, remove half the clothes prior to starting

the dry cycle.

1

1

Advertising