Warning, Installing the side vent kit – LG DLG4902W User Manual
Page 16
16
Installing the side vent kit
W
WARNING
t6TFBIFBWZNFUBMWFOU
t%POPUVTFQMBTUJDPSUIJOGPJMEVDU
t$MFBOPMEEVDUTCFGPSFJOTUBMMJOHUIJTESZFS
t5PSFEVDFUIFSJTLPGJOKVSZUPQFSTPOT BEIFSFUPBMM
JOEVTUSZSFDPNNFOEFETBGFUZQSPDFEVSFTJODMVEJOHUIF
VTFPGMPOHTMFFWFEHMPWFTBOETBGFUZHMBTTFT
t'BJMVSFUPGPMMPXBMMPGUIFTBGFUZXBSOJOHTJOUIJTNBOVBMDPVME
result in property damage, injury to persons, or death.
Your new dryer is shipped to vent to the rear.
It can also be configured to vent to the bottom or side (right-side
venting is not available on gas models).
An adapter kit, part number
&&-#, may be purchased
from your LG retailer. This kit contains the necessary duct
components to change the dryer vent location.
3FNPWFUIFSFBSFYIBVTUEVDUSFUBJOJOHTDSFX1VMMPVUUIF
exhaust duct.
OPTION 1: SIDE VENTING
1SFTTUIFUBCTPOUIFLOPDLPVUBOEDBSFGVMMZSFNPWFUIF
knockout for the desired vent opening (right-side venting is
not available on gas models). Press the adapter duct onto the
blower housing and secure to the base of the dryer as shown.
1SFBTTFNCMFBJODIFT DN FMCPXUPUIFOFYUJODIFT
DN
EVDUTFDUJPO
BOETFDVSFBMMKPJOUTXJUIEVDUUBQF#F
sure that the male end of the elbow faces AWAY from the dryer.
Insert the elbow/duct assembly through the side opening and
press it onto the adapter duct. Secure in place with duct tape.
#FTVSFUIBUUIFNBMFFOEPGUIFEVDUQSPUSVEFTJODIFT
cm) to connect the remaining ductwork.
Attach cover plate to the back of the dryer with included screw.
OPTION 2: BOTTOM VENTING
1SFTTUIFBEBQUFSEVDUPOUPUIFCMPXFSIPVTJOHBOETFDVSFUP
the base of the dryer as shown.
*OTFSUUIFJODIFT DN FMCPXUISPVHIUIFSFBSPQFOJOH
BOEQSFTTJUPOUPUIFBEBQUFSEVDU#FTVSFUIBUUIFNBMFFOEPG
the elbow faces down through hole in the bottom of the dryer.
Secure in place with duct tape.
Attach the cover plate to the back of the dryer with included
screw.
Rear
Exhaust Duct
Retaining
Screw
1
1
/
2
"
(3.8 cm)
Elbow
Cover
Plate
Elbow
Cover
Plate
,OPDLPVU
#SBDLFU
Adapter
Duct
#SBDLFU
Adapter
Duct
INSTALLATION INSTRUCTIONS