LG DLGX0002TM - Manual (Page 24)

Your dryer features FlowCheck ™ , an innovative
sensing system that automatically detects
blockages and restrictions in dryer ductwork.
Keeping ductwork clean of lint buildup and free
of restrictions allows clothes to dry faster and
reduces energy use.
NOTE: When the dryer is first installed, this test
should be performed to alert you to any existing
problems with the exhaust duct in your home.
However, since the test performed during normal
operation provides more accurate information on
the condition of the exhaust duct than does the
installation test, the number of bars displayed
during the two tests may not be the same.
To activate the flow check (Duct condition test) :
NOTE: Dryer heating test must be performed
before proceeding. Then perform the duct
condition test below:
Press the OPTION button, then select
CUSTOM PGM.
After 3 seconds, or
by pressing the EXIT
button, the display
will show the FLOW
CHECK start screen.
Press START/PAUSE. The dryer
will run for approximately 2
minutes to test
for blockages or
restrictions to air flow in the
ductwork.
FLOW CHECk (DUCT CONDITION TEST)
If no bars are shown in
the display, the ductwork
is free from blockages
or restrictions.
If all bars are lit, the
dryer ductwork has a
blockage that needs to
be removed immediately.
Correct Venting
1
2
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows
or bends.
Check for blockages and lint buildup.
Make sure the ductwork is not crushed
or restricted.
IMPORTANT: Do NOT interrupt the test cycle!
I N S TA L L AT I O N I N S T RU C T I O N S
CUSTOM PGM
*PGM SAVE
OPTION
*LANGUAGE
(*Press & hold 3 sec
for extra functions)
FLOW CHECK
THIS TEST CHECKS THE CONDITION
OF THE EXHAUST DUCT AT THE TIME
OF INSTALLATION
HIGH HIGH NORMAL
0:02 EST. TIME
REMAINING
FLOW CHECK
0:02 EST. TIME
REMAINING
HIGH HIGH NORMAL
THE DUCTWORK IS FREE
FROM BLOCKAGES OR
RESTRICTIONS.
COMPLETED FLOW CHECK
THE DUCTWORK HAS
A BLOCKAGE THAT NEEDS
TO BE REMOVED
IMMEDIATELY.
NEED FLOW CHECK
OFF I
FLOW CHECK