Care and cleaning, Oven door, Caution – LG LRG3091ST User Manual

Page 28

Advertising
background image

28

CARE AND CLEANING

OVEN DOOR

TO REMOVE THE DOOR
Step. 1

Open the door fully.

Step. 2

Pull the hinge locks down
toward the door frame to the
unlocked position.

Step. 3

Firmly grasp both sides of the door at the top.

Step. 4

Close door to the door removal
position, which is approximately 5
degrees.

Step. 5

Lift door up and out until the hinge arm
is clear of the slot.

Step. 1

Firmly grasp both sides of the door at the top.

Step. 2

With the door at the same angle as the removal position,
seat the indentation of the hinge arm into the bottom edge
of the hinge slot. The notch in the hinge arm must be fully
seated into the bottom of the slot.

Step. 3

Open the door fully. If
the door will not open
fully, the indentation is
not seated correctly in
the bottom edge of the
slot.

Step. 4

Push the hinge locks up
against the front frame
of the oven cavity to the locked
position.

Step. 5

Close the oven door.

The oven door is removable, but it is heavy. You may
need help removing and replacing the door.

TO CLEAN THE INSIDE OF THE DOOR

DO NOT allow excess water to run into any holes or
slots in the door.

Because the area inside the gasket in front of the cavity
is cleaned during the self clean cycle, you do not need
to clean this by hand.

The area outside the gasket can be cleaned with a
soap-filled plastic scouring pad.

TO CLEAN THE OUTSIDE OF THE DOOR

Use soap and water to thoroughly clean the top, sides
and front of the oven door. Rinse well. You may also use
a glass cleaner to clean the glass on the outside of the
door.

Spillage of marinades, fruit juices, tomato sauces and
basting materials containing acids may cause
discoloration and should be wiped up immediately.
When the surface is cool, clean and rinse.

DO NOT use oven cleaners, cleansing powders or harsh
abrasives on the outside of the door.

TO REPLACE THE DOOR

Slot

Hinge

lock

Lock

Unlock

about 5°

Hinge arm

Indentation

Bottom
edge of
slot

Hinge arm

Hinge lock

CAUTION:

M420A45D;F74=A4<>E8=60=3;85C8=6C743>>A
M%$%*;85CC743>>A1HC7470=3;4
*743>>A8BE4AH740EH

about 5°

Advertising
This manual is related to the following products: