LG CF181D - Manual (Page 16)

Installing and Composition
16
* Do not disconnect the power cord while the fan is in operation. It may shorten the life of the fan. It will also take longer to
activate the lamp when turning the power back on.
1. Make sure the power cord is connected correctly.
2. Remove the lens cap. If it is left on, it could become deformed due to the heat produced by the projection
lamp.
3. Press the POWER button on the remote control or back cover.
• An image will appear after the operation deco LED turns (Blue (flashing))(Refer to page 11).
• Press the
INPUT button on the remote control or the INPUT button on the control panel to select the input signal
you want.
1. Press the POWER button on the back cover or remote control.
2. Press the POWER button on the back cover or remote control again to turn off the power.
3. If the operation indicator is flashing orange, in other words the fan is working (60 seconds), do not discon-
nect the projector. When the indicator turns red, you may remove the power cord (Refer to page 11).
• If the operation indicator LED is orange and flashing, the power button on the back cover or on the remote control will
not operate.
Please press Power key again.
Power off?
Turning on the Projector
Turning off the Projector