LG CF181D - Manual (Page 33)

33
Information
1
Turn off the projector and unplug the power
cable. Carefully place on a cushioned surface.
(Allow the lamp to cool for 1 hour before removing
the used lamp from the projector.)
2
Unscrew the screw from the lamp cover using
a screwdriver.
Lamp cover screw
3
After lifting the lamp cover off, remove the two
retaining screws on the lamp case with a
screwdriver.
4
Lift the lamp up from the projector.
5
Pull out the handle slowly and remove the
lamp case.
6
Insert the new lamp gently into the correct
position. Push the lamp bottom to check if it
is correctly installed.
7
Tighten the screws you removed in step 3.
(Make sure they are fixed firmly.)
8 Close the lamp cover and install the screws
from step 2 to install the cover.
(If the lamp cover is not installed correctly the unit
will not power on.)
Replacing the Lamp
Screws
• Using another manufacturers lamp may cause damage to the projector or lamp.
• Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on.
• If this fault persists contact an LG Authorized Service Center.
Knob
bottom