Altinex MT105-110 - Manual (Page 12)

MULTI-TASKER
12
12
Example:
[OFF1C2U3F]: if path is not set
[OFF1C2U3PF]: if path is set
6. [SW] – Switch
The switch command immediately connects
inputs and outputs, which were previously set
with the path command on this card or any other
cards in the MT100-100.
Example:
[ON12C6U3P]
[ON34C7U3P]
[SW]
The system will return feedback as OK if the
unit ID is zero.
7. [WR]
This command groups multiple cards in the
MT100-100 Enclosure. Each unit contains a
maximum of nine groups.
Command Format: [WRCn…GkUi]
n = card ID No. (n = slot # from 1 to 19) (1 to 8
for MT100-101 or 1 to 4 for MT100-106
k = group number (k = # from 1-9)
i = unit number (i = # from 0-9)
Example:
To group card #1, 2, and 3 as group 5 of unit
#1, send the [WRC1C2C3G5U1] command.
After executing this command, card 1, 2, and 3
will be grouped as group 5 of unit 1.
OK or ER will be returned as feedback if "F" is
included at the end of a command string or if the
unit ID is zero.
8. [CLR]
This command clears the members for a single
group or for all nine groups.
[CLRCnUi]: for a single card
n = Card ID number (n = 1 to 19) (1 to 8 for
MT100-101 or 1 to 4 for MT100-106)
Ui = Unit ID number (i = 0 to 9)
Note that all outputs will be connected to input1.
[CLRGkUi]: for a group of cards
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
Example:
a) To clear group #1, send the [CLRG1U1]
command. This command clears the members
for the specified group only.
b) To clear all groups of unit 1, send the
[CLRG
[U1] command.
OK or ER will be returned as feedback if "F" is
included at the end of a command string or if the
unit ID is zero.
9. [G]
This command is used to request group data.
With the command, the user can identify which
input or output of a particular group is on.
Command Format: [GkUi]
Gk = group number (k = # from 1-9)
Ui = unit number (i = # from 0-9)
Example:
If group 1 has DA Cards with output 1, 2 and 3
on, while group 2 has SW Cards with input 2 on:
1) [G1]: will return feedback as [On123G1].
2) [G2]: will return feedback as [On2G2].