LG WM2496HSM - Manual (Page 17)

HOW TO USE THE WASHER
OPTION
CHILD LOCK
DOOR LOCKED
1 6
• Use this option for loads that need pretreatment. Adds
16 minutes prewash and a spin cycle.
1. Prewash
• Displays whenever the door of the washer is locked.
• The door can be unlocked by pressing the
Start/Pause button to stop the washer.
NOTE: If the water temperature or the level is too high, the
door cannot be unlocked.
Do not try to force the door open when
is displayed.
STATUS INDICATOR
• It shows elapsed time of the cycle the washer is
operating.
EST. TIME REMAINING
• This display shows the estimated time remaining
in the cycle when operating.
• This washer automatically detects the wash load
(weight) and optimizes the washing time. After
detecting, the display will show the adjusted time
remaining.
• Use this option to prevent unwanted use of the washer.
Press and hold PRE WASH button for 3 seconds to
lock/unlock control.
• When Child lock is set, “ ” blinks and all buttons are
disabled except the Power button. You can lock the
washer while it is operating.
• Adds extra water to the wash and rinse cycles for
superior results.
5. Water Plus
• This option provides an additional rinse.
• Use this option to ensure the removal of detergent or
bleach residue from garments.
3. Extra Rinse
• Use this option to rinse and then spin.
2. Rinse+Spin
• Adds more time to the wash and rinse cycles for better
stain removal.
• Automatically provides a rinse.
4. Stain cycle
• SPINSENSE TM can be used when there is a vibration
problem, especially on wood floor installations.
• To operate SPINSENSE TM press and hold the Stain
Cycle button for 3 seconds when the washing machine
is running on any cycle.
• When SPINSENSE TM has been selected, the Spin
Speed button light will blink on and off continually to
indicate that the SPINSENSE
TM function has been
selected.
• Push and hold the Stain Cycle button again for 3
seconds to cancel SPINSENSE TM .
• Once SPINSENSE TM has been selected, if will continue
to function even if interrupted by a power failure.
6. SPINSENSE TM
• A buildup of detergent residue can occur in the wash
tub over time and can lead to a mildewy or musty
smell. The Tub Clean cycle is specially designed to
remove this buildup.
• Press and hold the Extra Rinse button for 3 seconds to
activate this cycle.
• Add liquid chlorine bleach to the bleach compartment.
• After the cycle has ended, open the door and allow the
drum interior to dry completely.
NOTE: Do NOT use this cycle with clothes, and do NOT
add detergent or fabric softener.
7. Tub Clean