LG CF3D - Manual (Page 37)

Information
37
Replacing the Lamp
1. Turn off the projector and unplug the power cable. Carefully place on a cushioned surface. (Allow the
lamp to cool for 1 hour before removing the used lamp from the projector.)
2. Unscrew the screw from the lamp cover using a screwdriver.
Lamp cover screw
3. After lifting the lamp cover off, remove the two retaining screws on the lamp case with a screwdriver. Lift
the lamp up from the projector.
Screws
Lamp cover
Screws
Lamp bottom
Lamp Knob
4. Pull out the handle slowly and remove the lamp case.
5. Insert the new lamp gently into the correct position. Push the lamp bottom to check if it is correctly
installed.
6. Tighten the screws you removed in step 3. (Make sure they are fixed firmly.)
7. Close the lamp cover and install the screws from step 2 to install the cover. (If the lamp cover is not
installed correctly the unit will not power on.)
Using another manufacturers lamp may cause damage to the projector or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on.
If this fault persists contact an LG Authorized Service Center.