LG LP1411SHR - Manual (Page 12)

12
To turn the AUTO CLEAN function on, press the
AUTO CLEAN button while the air conditioner is
running inCOOL,DRY or ENERGY
SAVER mode. This function
can only be selected from the
remote;it is not available from
the control panel.It must be set
each time you wish to run the AUTO CLEAN
function.
AUTO CLEAN is used to remove moisture from
the heat exchange coils. This helps prevent the
formation of mildew and odors.
To use AUTO CLEAN
With the air conditioner running in COOL,
DRY ,ENERGY SAVER or HEAT mode, press the
AUTO CLEAN button.
“ AUTO CLEAN” will be displayed in the
LCD diplay.
Press the POWER button to turn the air
conditioner off. AUTO CLEAN will run
the circulation and exhaust fans with the
compressor off for a few minutes after
the power is turned off.
To cancel AUTO CLEAN, or to stop an
AUTO CLEAN cycle in process, simply press
the AUTO CLEAN button again. The AUTO CLEAN
function will not operate if the air conditioner is
already off.
AUTO CLEAN
1
2
AUTO SWING function can only be activated with
the remote. When this function is on, the air
discharge will oscillate to
circulate air more evenly
through the room. To turn this
function off, simply press the
AUTO SWING button with the
remote again.
With
AUTO SWING off, you may also manually
adjust the air discharge to the desired position.
It will maintain this position until the air
conditioner is turned off or AUTO SWING
is activated.
AUTO SWING
function can only be activated with the
remote.When the displayed
temperature is °C(of °F),you
can press this button to swith
to °F(or °C) .
USING THE CONTROLS
HOW TO U SE