Troubleshooting, Specifications – LG MCD212 User Manual

Page 11

Advertising
background image

MINI Hi-Fi SYSTEM ] USER GUIDE

11

Troubleshooting

Symptom

Cause

Correction

Specifications

General
Net Weight

5.57 kg (MCD212)
5.36 kg (MCD112

/MCD112B)

External dimensions (WxHxD) 270 x 310 x 390 mm

Tuner
FM Tuning Range

87.5 - 108.0 MHz or 65 - 74 MHz,
87.5 - 108.0 MHz

AM Tuning Range

522 - 1620 kHz or 520 - 1720 kHz

Amplifier
Output Power

100W + 100 W (MCD212)
50W + 50 W (

MCD112/MCD112B)

T.H.D

0.5 %

Frequency Response

40 - 20000 Hz

Signal-to-noise ratio

75 dB

CD
Frequency response

40 - 20000 Hz

Signal-to-noise ratio

75 dB

Dynamic range

75 dB

Speakers
MCS212F
Type

Bass Reflex 2 Way 2 Speaker

Impedance

4 Ω

Rated Input Power

100 W

Max. Input Power

200 W

Net Dimensions (WxHxD) 220 x 326 x 272 mm
Net Weight (1EA)

3.25kg

MCS112F Type

Bass Reflex 2 Way 2 Speaker

Impedance

4 Ω

Rated Input Power

50 W

Max. Input Power

100 W

Net Dimensions (WxHxD) 200 x 326 x 228 mm
Net Weight (1EA)

2.92 kg

No power.

No sound.

The unit does not
start playback.

The remote
control does not
work properly.

Unable to record.

• The power cord is disconnected.

• The power of the external source

equipment is turned off.

• The speaker cable is connected

to a wrong position.

• An unplayable disc is inserted.

• The disc is placed upside down.

• The disc is not placed within the

guide.

• The disc is dirty.

• The remote control is not pointed

at the remote sensor of the unit.

• The remote control is too far from

the unit.

• There is an obstacle in the path

of the remote control and the unit.

• The batteries in the remote con-

trol are exhausted.

• Record protect tabs are removed.

• Plug the power cord into the wall

outlet securely.

• Switch on the external source

equipment.

• Set the speaker cable to the

correct position, then turn on the
unit again by pressing POWER.

• Insert a playable disc.

• Place the disc with the playback

side down.

• Place the disc on the disc tray

correctly inside the guide.

• Clean the disc.

• Point the remote control at the

remote sensor of the unit.

• Operate the remote control within

about 23 ft (7 m).

• Remove the obstacle.

• Replace the batteries with new

ones.

• Cover holes on back edge of tape

with tap.

Designs and specifications are subject to change without notice.

Advertising