LG LHB975 - Manual (Page 21)

21 Installation
3
Installation
About Ferrite Core (for EMI only)
Be sure to attach the ferrite core to the speaker
cable (for connecting to this unit and wireless
receiver). This ferrite core can reduce noises.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to
open.
2. Wind the speaker cables once on the ferrite
core.
3. Close the ferrite core until it clicks.
Refer to the fi g.3 and comment.
The length
here is as
short as
possible.
Rear of wireless
receiver
Positioning the system
The following illustration shows an example
of positioning the system. Note that the
illustrations in these instructions diff er from the
actual unit for explanation purposes.
For the best possible surround sound, all the
speakers other than the subwoofer should be
placed at the same distance from the listening
position (A).
A
B
D
E
F
A
A A
A
A
G
C
A Front left speaker (L)/
B Front right speaker (R):
Place the front speakers to the sides of the
monitor or screen and as fl ush with the screen
surface as possible.
C Center speaker:
Place the center speaker above or below the
monitor or screen.
D Surround left speaker (L)/
E Surround right speaker (R):
Place these speakers behind your listening
position, facing slightly inwards.
F
Subwoofer:
The position of the subwoofer is not so
critical, because low bass sounds are not
highly directional. But it is better to place
the subwoofer near the front speakers. Turn
it slightly toward the center of the room to
reduce the wall refl ections.
G Unit
HB965PZT-AD.BUSALL_ENG_6864.indd 21 HB965PZT-AD.BUSALL_ENG_6864.indd 21 10. 10. 20 9:16 10. 10. 20 9:16