Power management setup, 6 power management setup -26, 6 power management setup – Abit AW9D-MAX User Manual
Page 62
3.6 Power Management Setup
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
ACPI Suspend Type
S3(Suspend To RAM)
Item Help
- Resume by USB From S3
Enabled
Power Button Function
Instant-Off
Wake Up by PME# of PCI
Disabled
Wake Up by WAKE# of PCIe
Disabled
Wake Up by Onboard LAN1
Disabled
Wake Up by Onboard LAN2
Disabled
Wake Up by Onboard 1394
Disabled
Wake Up by Alarm
Disabled
X - Date(of month) Alarm
0
X - Time(hh:mm:ss) Alarm
0 : 0 : 0
Power On Function
Button Only
X - KB Power On Password
Enter
X - Hot Key Power On
Ctrl-F1
Restore On AC Power Loss
Power Off
↓↑→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
ACPI Suspend Type
This item selects the type of Suspend mode.
[S1(PowerOn Suspend)]: Enables the Power On Suspend function.
[S3(Suspend To RAM)]: Enables the Suspend to RAM function.
-
Resume by USB From S3
When set to [Enabled], this item allows you to use a USB device to wake up a system that is in
the S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPI
Suspend Type” is set to [S3(STR)].
Power Button Function
This item selects the method of powering off your system:
[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system.
This will prevent the system from powering off in case you accidentally hit or pushed the power
button.
[Instant-Off]: Pressing and then releasing the power button at once will immediately power
off the system.
Wake Up by PME# of PCI
When set to [Enabled], access through the add-on PCI card can remotely wake up the system
that was in Soft-Off condition. The PCI card must support the wake up function.
3-26 AW9D-MAX,
AW9D