ATI Technologies THEATER 550 - Manual (Page 10)

5
Installing your THEATER™ 550 PRO TV tuner card
1 Turn off the computer, monitor, and other peripheral devices.
2 Unplug the computer’s power cord, and disconnect all cables from
the back of your computer.
3 Remove the computer cover. If necessary, consult your computer’s
manual for help in removing the cover.
4 Locate an available PCIe X1 or PCI slot (as appropriate) and, if
necessary, remove the metal back-plate cover.
5 Align your THEATER™ 550 PRO TV tuner card with the
appropriate slot, and then press it in firmly until the card is fully
seated.
6 Screw in or fasten the THEATER™ 550 PRO TV tuner card
securely. Replace your computer cover.
7 Reconnect any cables you have disconnected, and then plug in the
computer’s power cord.
8 Attach a TV antenna or cable cord to the TV connector on your
THEATER™ 550 PRO TV tuner card.
9 Attach an FM antenna to the FM connector on your THEATER™
550 PRO TV tuner card. If your cable service provides an FM signal,
you can use a splitter to connect the cable to the FM and TV
connectors on your card.
L WARNING - Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or removing a
component from the motherboard to avoid possible damage to the
motherboard.
L WARNING - Remember to discharge your body’s static electricity
by touching the power supply or the metal surface of the computer
chassis before touching the motherboard or components.
THEATER 550.book Page 5 Friday, January 21, 2005 9:31 AM