Altinex MT105-101 - Manual (Page 13)

MULTI-TASKER™
400-0131-004 12
12
9. [OFF]
This command disables one or all outputs of a
single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCnUi]
m = Output number (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Card 5 has Output 1 on. The following
commands may be used to turn off the output.
1) [OFF1C5]: Turns off only Output 1.
2) [OFFC5]: Turns off all outputs.
GROUP OPERATION
This command disables output “m” for each
card in group “k” of unit “i”.
Command Format: [OFFmGkUi]
m = Card Output (m = # from 1-8)
Gk = Group ID (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
1. [OFF1G1]: Turns off Output 1 for each card
in group 1.
2. [OFFG1]: Turns off all outputs for each
card in group 1.
PATH OPERATION
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in “P” are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
Command Format: [OFFmCnUiP]
m = Output (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
P = Path
Example:
There are two MT105-100 cards in slots 6 and
9. Disable Output 1 of card 6 and Output 3 of
card 9
simultaneously using the following
commands:
[OFF1C6P] , [OFF3C9P] and [SW]
If “F” is included, use the [OFFmCnPF]
command or the [OFFmCnFP] command.
FEEDBACK OPERATION
After processing a command, an “OK” or
“[ERR001]” will be returned as feedback if “F” is
included at the end of a command string.
Command Format: [OFF…..F]
Example:
[OFF1C2F]: if path is not set
[OFF1C2PF]: if path is set
10. […S] – SAVE
This command will save the configuration
command being sent in memory. When
sending the command [I1O1C4S], after reset or
power up, Input 1 will be connected to Output 1
on C4. This command only saves the Input 1 to
Output 1 connection above. In order to save all
the current settings, use the [CnS] command.
11. […F] – FEEDBACK
After processing a command, an “OK” or
“[ERR001]” will be returned as feedback if "F" is
included at the end of a command string.