0 installation – APC 2000 User Manual
Page 17
Advertising
Page 15
4.0 Installation
4.3 Connect battery pack - 2000VA model only
Follow the instructions listed below to install and lock the battery pack coupler.
Note:
Use only factory supplied or authorized battery packs!
4.3.1
Use a phillips screwdriver to remove the battery coupler clamp from the electronics
enclosure.
4.3.2
Turn the battery coupler clamp and refasten loosely at one side.
4.3.3
Mate the battery pack coupler to the electronics enclosure.
4.3.4
Fasten remaining side of battery coupler clamp to lock in place.
4.4 Connect UPS to service and enable
4.4.1 Connect UPS to service
■ 100, 120 Vac versions
Plug the UPS into a two-pole, three wire grounding
receptacle only. Avoid the use of extension cords and
adapter plugs.
Advertising