LG F1402FDS5 User Manual

Te fe pe le ae pf, Roubleshooting guide

Advertising
background image

29

arantiebedingungen

G

Unter die Garantie fallen nicht:

• Heimservice zur Einführung in die Benutzung des Geräts.
• Wenn das Gerät an eine Spannung angeschlossen ist, die nicht mit der auf dem

Nennleistungsschild angegebenen übereinstimmt.

• Wenn die Störung durch Unfälle, Vernachlässigung, Missbrauch oder höhere Gewalt

verursacht wird.

• Wenn die Störung durch unsachgemäße Benutzung des Geräts oder Nichtbeachtung

der Bedienungsanleitung verursacht wird.

• Die Gebrauchsanweisung für das Gerät zur Verfügung stellen oder die Einstellungen

des Geräts ändern.

• Wenn die Störung durch Schädlinge wie Ratten oder Kakerlaken etc. verursacht wird.
• Normale Geräusche oder Vibrationen z. B. das Geräusch von ablaufendem Wasser,

Drehgeräusche oder Pieptöne während der Erwärmung.

• Die Installation korrigieren, das Gerät nivellieren oder den Abfluss einstellen.
• Normale Wartung, wie sie im Benutzerhandbuch empfohlen wird.
• Entfernung von Fremdkörpern wie Sand, Nägeln, BH-Bügeln, Knöpfen etc. aus der

Maschine sowie aus der Pumpe und dem Einlassfilter.

• Sicherungen ersetzen oder die elektrischen Anschlüsse oder Rohrleitungen korrigieren.
• Korrektur von unbefugten Reparaturen.
• Schäden an persönlichem Eigentum, die direkt oder indirekt durch Defekte dieses

Geräts verursacht werden.

• Wenn dieses Gerät zu kommerziellen Zwecken benutzt wird, steht es nicht unter Garantie.

(Beispiel: öffentliche Orte wie Toiletten, Hotels, Fitness-Center, Pensionen)

Entsorgung von Altgeräten

1. Wenn dieses Symbol eines durchgestrichenen Abfalleimers

auf einem Produkt angebracht ist, unterliegt dieses Produkt
der europäischen Richtlinie 2002/96/EC.

2. Alle Elektro- und Elektronik-Altgeräte müssen getrennt vom

Hausmüll über dafür staatlich vorgesehenen Stellen entsorgt
werden.

3. Mit der ordnungsgemäßen Entsorgung des alten Geräts

vermeiden Sie Umweltschäden und eine Gefährdung der
persönlichen Gesundheit.

4. Weitere Informationen zur Entsorgung des alten Geräts

erhalten Sie bei der Stadtverwaltung, beim Entsorgungsamt
oder in dem Geschäft, wo Sie das Produkt erworben haben.

4

1

2

3

5

7

5

3

. Die 4 Schrauben lösen und die

Gummipfropfen etwas drehen, um sie

zusammen mit den Schrauben abzunehmen.

Die 4 Schrauben und den Schraubenschlüssel

für späteren Gebrauch aufbewahren.

• Die Transportsicherungsschrauben müssen vor

jedem Transport des Geräts wieder angebracht

werden.

4

. Die Schraubenbohrungen mit den

beiliegenden Kappen verschließen.

1

2

3

4

Schraubenschlüssel

Green and Yellow(Earth)

Brown(Live)

Blue(Neutral)

Fuse

Cord

grip

E

L

N

6

Фиксатор

шланга

Бак для белья

Крепежный

ремень

мин. 60 см

макс. 100 см

мин. 60 см

макс. 100 см

60 - 100 cm

@

29

roubleshooting guide

Symptom

Possible Cause

Solution

• Water supply is not adequate in

area

• Water supply taps are not

completely open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are

clogged.

• If water leakage occurred in the inlet hose,

indicator “ ” will be changed red color.

• Drain hose is kinked or clogged.
• The drain filter is clogged.

• Load is too small.
• Load is out of balance.
• The appliance has an unbalance detection

and correction system. If individual heavy
articles are loaded (ex. bath mat, both robe,
etc.), this system may stop spinning or even
interrupt the spin cycle altogether.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.

• Is the door opened or not

completely closed?

• Water overfills due to the faulty water

valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• Water leaks

• The washer experienced a power failure.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose(s).

Clean and straighten the drain hose.

Clean the drain filter.

For more detailed information,

please refer to “The drain pump filter”
on page24

Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper

spinning

Close the door completely.

If “ ”is not released, call for service.

Unplug the power plug and call for service.

Close the water tap.
Unplug the power plug.
Call for service.

Call for service.

Restart the cycle.

<Fig 1>

T

29

roubleshooting guide

Symptom

Possible Cause

Solution

• Water supply is not adequate in

area

• Water supply taps are not

completely open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are

clogged.

• If water leakage occurred in the inlet hose,

indicator “ ” will be changed red color.

• Drain hose is kinked or clogged.
• The drain filter is clogged.

• Load is too small.
• Load is out of balance.
• The appliance has an unbalance detection

and correction system. If individual heavy
articles are loaded (ex. bath mat, both robe,
etc.), this system may stop spinning or even
interrupt the spin cycle altogether.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.

• Is the door opened or not

completely closed?

• Water overfills due to the faulty water

valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• Water leaks

• The washer experienced a power failure.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose(s).

Clean and straighten the drain hose.

Clean the drain filter.

For more detailed information,

please refer to “The drain pump filter”
on page24

Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper

spinning

Close the door completely.

If “ ”is not released, call for service.

Unplug the power plug and call for service.

Close the water tap.
Unplug the power plug.
Call for service.

Call for service.

Restart the cycle.

<Fig 1>

T

29

roubleshooting guide

Symptom

Possible Cause

Solution

• Water supply is not adequate in

area

• Water supply taps are not

completely open.

• Water inlet hose(s) are kinked.

• The filter of the inlet hose(s) are

clogged.

• If water leakage occurred in the inlet hose,

indicator “ ” will be changed red color.

• Drain hose is kinked or clogged.
• The drain filter is clogged.

• Load is too small.
• Load is out of balance.
• The appliance has an unbalance detection

and correction system. If individual heavy
articles are loaded (ex. bath mat, both robe,
etc.), this system may stop spinning or even
interrupt the spin cycle altogether.

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.

• Is the door opened or not

completely closed?

• Water overfills due to the faulty water

valve.

• Water level sensor has malfunctioned.

• Over load in motor.

• Water leaks

• The washer experienced a power failure.

Check another tap in the house.

Fully open tap.

Straighten hose(s).

Check the filter of the inlet hose(s).

Clean and straighten the drain hose.

Clean the drain filter.

For more detailed information,

please refer to “The drain pump filter”
on page24

Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper

spinning

Close the door completely.

If “ ”is not released, call for service.

Unplug the power plug and call for service.

Close the water tap.
Unplug the power plug.
Call for service.

Call for service.

Restart the cycle.

<Fig 1>

T

N

i

i

Закройте отверстия
прилагаемыми крышками.

P/No. :MFL41480129

tE

FE

PE

LE

AE

PF

Advertising
This manual is related to the following products: