Atapi support, Using sataselect, Using sata select – Adaptec ATA II 1220SA User Manual

Page 57

Advertising
background image

Appendix B: Using the ARC Utility

57

4

Press Enter.

5

Read the warning message and ensure that you have selected the correct disk drives to
configure. Type

Y

to continue.

ATAPI Support

The following devices are supported:

The 1220SA supports detection of SATA ATAPI TAPE Drive and CDROM.

The 1220SA supports booting from the ELTORITO bootable CD/DVD media.

If a bootable CD/DVD media is detected, that bootable media gets precedence in the
booting order.

Using SATASelect

The SATASelect utility allows you to change the BIOS and HostRAID controller and device
settings without opening the computer cabinet.

For information on the SATASelect options, see

SATASelect Options on page 58

. To access

SATASelect:

1

Restart the computer, then press Ctrl+A when prompted to access the ARC utility.

2

If multiple HostRAID controllers are installed, select the HostRAID controller you want to
configure, then press Enter.

3

From the ARC menu, select SATASelect Utility.

4

To select a menu option, browse with the arrow keys to the option, then press Enter. In
some cases, selecting an option displays another menu. You can return to the previous
menu at any time by pressing Esc.

5

To restore the original SATAlSelect default values, press F6 from within the SATA Driver
and Controller Configuration screens.

6

To exit SATASelect, press Esc until a message prompts you to exit (if you changed any
settings, you are prompted to save the changes before you exit).

7

At the prompt, select Yes to exit, then press any key to restart the computer. Any changes
you made in SATAlSelect take effect after the computer restarts.

Advertising
This manual is related to the following products: