HP StoreEver Ultrium Tape Drives - Manual (Page 17)

Figure 9 Attaching mounting rails
CAUTION: Ensure you use the 4mm M3 screws provided. The rails may be attached to the filler
panel by screws of a different thread/size type and these should not be used. If the screws are
too long, they may penetrate the mechanism and void the warranty.
Mounting screws
Other HP ProLiant server models, such as ML350 and ML370, only require the use of special
locating screws with no mounting rail.
Use a T8 Torx screwdriver to attach the appropriate screws. Locate both screws lightly in position
before tightening, as shown in the following figure.
•
HP ProLiant ML350: Use the metal shims and screw pack labeled ‘ProLiant ML350'. These
are 3mm screws and have a thicker head than the general mounting screws.
•
HP ProLiant ML370: Use the metal shims and screw pack labeled ‘ProLiant ML370'. These
are shoulder screws and have a thick offset piece and a thicker head than the general mounting
screws.
Figure 10 Attaching locating screws in a typical HP ProLiant ML350 or ML370
1. 3mm mounting screws ((ProLiant ML350 screw pack)
2. Shoulder mounting screws (ProLiant ML370 screw pack)
Attach mounting hardware - some servers 17