HP Compaq t5510 Thin Client - Manual (Page 118)

5-62
Setup Menus
Send All Selected Areas
Factory default: Selected
When the Send Only Selected Characters option is selected, the setting of this option
determines whether all selected areas on a page are sent to the host when the Enter key
is pressed, or only the area containing the cursor.
When selected, this option will enable all selected areas to be sent to the host. When
unselected, only the selected area containing the cursor will be sent to the host.
Line Transmission On
Factory default: Unselected
The setting of this option determines whether data is sent to the host a single line at a
time or a full or partial page at a time when the Enter key is pressed.
When selected, a single line of valid characters will be sent to the host. In this mode the
Return key has the same function as Enter. When unselected, a full or partial page
will be sent to the host when the Enter key is pressed. The size of the page is
determined by the setting of the Send Partial Page and Transmit Protocol options.
Send Font Information
Factory default: Selected
The setting of this option determines whether character set selection sequences for all
character sets represented in the data block are transmitted to the host, or whether
spaces are substituted for characters not contained in the current character set.
When selected, the character set selection sequences for all character sets represented in
the data block will be sent. When unselected, characters which are not contained in the
currently selected National or Multinational character set will be substituted with
spaces.
Send Record Separators
Factory default: Selected
The setting of this option determines whether or not a record separator (RS) code is
appended to each field of data when a block is transmitted to the host. Record
separator codes are used as markers between each field when this option is selected.
Send Spaces Compressed
Factory default: Unselected
This option determines how spaces and empty character fields within a block of data
are sent to the host.
When unselected, a space character will be sent for each empty character position.
When selected, a record separator code (RS) will be sent in place of empty character
positions. The last field on a line will contain end of line characters as specified by the
End of Line Characters option.