HP Matrix Operating Environment Software - Manual (Page 117)

Deleting network or storage devices
For details about deleting network or storage devices for vPars, see “Deleting network or storage
devices” (page 105) .
Deleting vPars
Deleting a vPar removes all configuration files for the vPar and frees up any resources assigned
to it, thereby the available resources can be assigned to other vPars. Deleting a vPar does not
delete files and data residing on the virtual storage or backing storage that is assigned to the vPar.
NOTE: Before you remove a vPar, you must stop the vPar or put to Off state (powered off).
By default, vswitch VLAN port assignments are removed when the vPar is deleted. If any of the
ports are connected to other vPars that are not removed, those port assignments are not removed.
Clearing the Remove VLAN Assignment check box causes vswitch VLAN port assignments to remain
after the vPar is deleted.
To remove one or more vPars:
1. Select one or more vPars from the Virtual Servers tab.
2. Select Delete
→Delete Virtual Partition. The Delete Virtual Partition screen is displayed.
Figure 79 Delete virtual partition
3. Click OK to delete the selected vPars.
Opening iLO console
For details about opening iLO console, see “Opening iLO console” (page 106) .
Opening virtual iLO remote console
For details about opening virtual iLO remote console, see “Opening virtual iLO remote console”
(page 107) .
Deleting virtual iLO remote console
For details about deleting virtual iLO remote console, see “Deleting virtual iLO remote console”
(page 108) .
Adding DIOs
For details about the adding DIOs, see “Adding DIOs” (page 109) .
Working with vPars 117