Disassembly procedures, Warning – Amana RS2320006 User Manual

Page 11

Advertising
background image

Disassembly Procedures

11

RS2320006 Rev. 0

To avoid risk of electrical shock, personal injury or death;

disconnect power supply source before servicing, unless

testing requires it.

WARNING

!

Oven Door Handle, Outer/Inner Glass, and

Door Hinges

1. Open or remove storage drawer to avoid damaging

finish.

2. Fully open the oven door, while open rotate both

hinge locking tabs into the LOCK position.

Hinge Lock

Oven
Door

3. Close oven door about all the way. The hinge locking

tabs will prevent the door closing completely.

4. Lift up equally on both sides of oven door. Hinges will

disengage from hinge receivers and oven door can

be removed.

5. Place oven door, with outer door glass facing

downward on a padded flat surface.

6. While supporting outer door glass, remove screws

securing left and right side the OVEN DOOR

HANDLE.

7. Again support outer door glass and turn door

assembly so outer door glass is facing upward and

remove outer oven door glass.

NOTE: May need to loosen screws in bottom glass

retainer.

8. Remove screws and neoprene washer from the

bottom of OVEN DOOR HINGE and one screw

securing oven door hinge to the door assembly.

NOTE: Hinges are interchangeable.
9. Remove screws securing top of door trim. Lift up and

twist trim towards bottom of door to disengage plastic

finger tabs.

10.All outer perimeter door trim can now be removed.

11. After removing the OFFSET screws from left and

right door glass trim, access is gained to the door

glass heat shield.

12.Remove screws from each side and screws from top

of door glass heat shield. Note position of plastic door

handle supports remove same.

13.Lift out galvanized insulation retainer and fiberglass

insulation.

14.Remove the tempered glass panes individually as

well as the glass frame.

NOTE: Tempered glass panes do not have an inner or

outer side. Be careful of fingerprints before

reassembly.

NOTE: Position replacement hinges into “LOCK”

position by using channel lock pliers PRIOR to

installing oven door on range.

Door
Handle

Oven
Door
Window

Door Glass
Heat Shield

Top Door
Trim

Side Door
Trim

Side Door
Trim

Glass Support

Heat
Shield

Window
Glass

Window
Frame

Door
Hinge

Door
Hinge

Oven
Door
Backer

Door
Handle
Screw

Bushing

Advertising