Amana RS2320006 - Manual (Page 20)

RS2320006 Rev. 0 A–4
POSITION AND
LEVEL RANGE
Place range near final position and
plug in. Then, slide range into final
position and adjust all legs (4) until
range is level side to side and front
to back.
• Place a level on top oven rack or
on range top when leveling.
• Leveling legs must extend ¼" to
engage anti-tip bracket.
3
Removal and Replacement of Range
1. Disconnect power to range.
2. Slide range forward.
3. Unplug range cord and place range aside.
4. Remove anti-tip bracket.
5. Install anti-tip bracket into new location using instructions provided
with bracket or see Anti-tip Bracket installation section in this
manual.
6. To reinstall range, follow instructions in this manual.
Remove
Storage
Drawer and
Check Anti-tip
Bracket
After range is in position,
remove storage drawer or lower
panel and confirm anti-tip bracket is
engaged with range leveling leg.
To remove storage drawer
1. Slide drawer out until it stops.
2. Grasp drawer sides near back of
drawer.
3. Lift up and out. Reverse to
reinstall.
Questions?
See Owner’s Manual or call Amana
Consumer Affairs Department
1-800-843-0304
To avoid
damaging oven
door, do not lift or
move range by
oven door handle.
Glass can break.