AT&T E5833B - Manual (Page 3)

Telephone line cord
DSL filter
(Optional for DSL users,
see number four in the
note section, below.)
Telephone base installation
5. Plug the other end of the tele-
phone line cord into a telephone jack.
4. Plug the large end of
the larger power adapter
into an electrical outlet
not controlled by a wall
switch.
3. Route cords through
slots.
1. Plug the small end of the larger
power adapter into the power jack at
the bottom of the telephone base.
2. Plug the end of the telephone line
cord into the telephone jack at the
bot tom of the telephone base.
NOTES:
1. Use only the power adapter supplied with this product or equivalent.
To order a replace-
ment power adapter, visit our website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL),
and you are experiencing interference during telephone conversations and/or your caller ID
features are not functioning properly, install a DSL filter to the telephone line between the tel-
ephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.
6 . You may be able to make or
receive short calls. For best per-
formance, place the handset in
the telephone base or charger to
charge for at least 16 hours before
first use.