KAL EQUIP KAL 3840 - Manual (Page 14)

CONTINUTY
OHM
OPEN CLOSE
IGNITION DI SECONDARY
VEHICLE WFM CYLINDER
BACK RUN
DATA ERASE PARADE
Function Key Labels
Function keys
Figure 8. Function Key Labels for SECONDARY IGNITION
Figure 8. Single and Dual Input scope in COMPONENT TESTS
BACK SELECT
HELP MENU
PIN # / WIRE COLOR
TEST PROCEDURE
REFERENCE WAVEFORM
THEORY OF OPERATION
TROUBLESHOOTING TIPS
FUNCTION INFORMATION
HELP ( )
DI Primary
Page 1 of 2
Function Info
VEHICLE CYLINDER FAST KEYS
DATA UPDATE
Giv es a l ist of o ptio ns to d efin e
the type of vehicle under test.
S IN GLE -d i sp l a ys th e i g ni ti o n
pattern of one single cylinder.
P AR AD E-d i sp la ys th e ig n iti o n
p atte rn of al l cyl in de rs in fi rin g
order.
PAGE
BACK
DOWN
VEHICLE
DATA
DI Primary
Page 2 of 2
Function Info
VEHICLE CYLINDER FAST KEYS
DATA UPDATE
Turns all readings off to make the
me a sur em en t fa ste r an d m ore
reliable.
You can adjust trigger level for a
stab le d isp la y b y u sin g the fou r
way arrow keys.
PAGE
BACK
UP
SINGLE TRIG LVL
FAST
UPDATE
CYLINDER
SINGLE
PARADE
SINGLE TRIG LVL
KEYS
TRIG LVL
Figure 7. Information About the Function keys
4-13
Getting Reference Information for the Selected Test
Reference information is available at any time by pressing the HELP key.
Press when finished viewing each area under the HELP menu.
Getting Information About the Function Keys During a Running Test
HELP ( ) When you press this key during a running test, you get information about the function keys that can
be used for the test.
For example,
4-12
CYLINDER
PARADE
SINGLE
Screen Displays
Use Dual Input Scope mode if you want to simultaneously measure t wo wavef orms - one on INPUT A and the other
on INPUT B.
Use SINGLE INPUT SCOPE mode if you want to measure a single signal, INPUT B is turned off.
Use DUAL INPUT SCOPE mode if you want to simultaneously measure two signals.
Using the Function keys
For each test, one or more Function Key Labels are displayed, depending on the sub-selections possible. The
Labels indicate what the keys do when you press them. (See the following example.)
Pressing a function key that has no label has no effect.
The same Function Key Label can appear in several tests and it performs a similar function.
Examples of Function Key Labels
Two separate functions can be allowed to the same function key.
You can use the function key to toggle between the functions.
When you press , you can select between PARADE and SINGLE cylinder test.
When you press , OHM becomes the active function. When
you press , Diode ( ) becomes the active function. When
you press , OPEN CONTINUITY becomes the active function.
Pressing , CLOSE CONTINUITY becomes the active function.