HP FlexFabric 10Gb 2-port 534M Adapter User Manual
Page 15
Configuration 15
•
Session format error is the number of sessions with errors due to inconsistent fields, reserved fields that
are not 0, non-existent LUNs, and so forth.
•
Sessions failed is the number of failed sessions.
Custom statistics
Total Offload iSCSI Connections is the total number of offloaded iSCSI connections.
Session Statistics
The statistics in this area only pertain to the named session.
•
Session Name is the name used for the session between the initiator and the target.
•
Session Id is the identifier used for the session between the initiator and the target.
•
Bytes sent is the number of bytes sent for the named session.
•
Bytes received is the number of bytes received for the named session.
•
PDU sent is the number of iSCSI PDUs sent for the named session.
•
PDU received is the number of iSCSI PDUs received for the named session.
•
Digest errors is the number of errors due to an invalid payload or header for the named session.
•
Connection Timeout errors is the number of connection timeout errors for the named session.
•
Format errors is the number of errors due to inconsistent fields, reserved fields not 0, non-existent LUN,
and so on for the named session.
IEEE 802.3 Statistics
•
Frames Rx with Alignment Error provides a count of the frames that were not an integral number of
octets in length and do not pass the FCS check. This counter is incremented when the receive status is
reported as Alignment Error.
•
Frames Tx with one Collision provides a count of the frames that were involved in a single collision and
were subsequently transmitted successfully. This counter is incremented when the result of a transmission
is reported as Transmit OK, and the attempt value is 2.
•
Frames Tx with more than one Collision provides a count of the frames that were involved in more than
one collision and were subsequently transmitted successfully. This counter is incremented when the
transmit status is reported as Transmit OK, and the value of the attempts variable is greater than 2 and
less than or equal to the attempt limit.
•
Frames Tx after Deferral provides a count of the frames that were delayed being transmitted on the first
attempt because the medium was busy. The frames involved in any collision are not counted.
Custom Statistics
Custom statistics are available only for certain enabled network adapters.
•
Out of Recv provides the number of times the adapter ran out of Receive Buffer Descriptors. This
information is only available for certain adapters.
•
Frames size less than 64-byte with bad FCS provides the number of frames with a size less than 64 bytes
with bad FCS.
•
MAC Rx w/ Pause Command and Length = 0 provides MAC control frames with the pause command
and a length equal to 0.
•
MAC Rx w/ Pause Command and Length greater than 0 provides MAC control frames with the pause
command and a length greater than 0.