HP FlexFabric 10Gb 2-port 534M Adapter - Manual (Page 12)

Configuration 12
o LSO prevents an upper level protocol such as TCP from breaking a large data packet into a series
of smaller packets with headers appended to them.
o CO allows the TCP/IP/UDP checksums for send and receive traffic to be calculated by the adapter
hardware rather than by the host CPU.
• LiveLink IP Address is the network address of the LiveLink enabled adapter.
• Local Connection identifies the module to which the blade server is attached.
o Chassis SW is the chassis switch module.
o Chassis PHY is the pass-through module.
o None indicates that no modules are attached.
• BASP State provides information about the status of the BASP application. This information is displayed
only when there is a team.
Managing the LAN device
The LAN function represents the Ethernet (NDIS) functionality available under the PCI Function. Select the
FCoE object in the object explorer panel to view current values of various NDIS driver parameters, configure
NDIS driver parameters, and view the attached FCoE targets and LUN information.
At the NDIS level, view and configure parameters from the Information and Configuration tabs.
Viewing NDIS information
Select the NDIS driver in the Explorer View pane, and then select the Information tab to view NDIS-level
information.
The available information depends on the installed network adapter.
Viewing driver information, vital signs, and SR-IOV information
Driver Information
• Driver Status provides status of the adapter driver.
o Loaded is the normal operating mode. The adapter driver has been loaded by Windows and is
functioning.
o Not Loaded indicates that the driver associated with the adapter has not been loaded by Windows.
o Information Not Available indicates that the value is not obtainable from the driver that is associated
with the adapter.
• Driver Name is the file name of the adapter driver.
• Driver Version is the current version of the adapter driver.
• Driver Date is the creation date of the adapter driver.
Vital Signs
• IP Address is the network address associated with the adapter. If the IP address is all 0s, the associated
driver has not been bound with Internet IP.
• IPv6 IP Address is the IPv6 network address associated with the adapter.