Figure 18, Installing rails in an hp rack system/e 45 – HP StorageWorks 2405 Disk System User Manual
Page 45
Advertising
Installation
45
In
st
al
la
ti
o
n
Note
Be sure to use the same tab—upper or lower—on opposing rails.
Also, hole patterns vary at opposite ends of the rails.
5
Insert the rail tabs into the appropriate column holes (see A in Figure 18).
6
Secure the rail ends with one M5 screw each.
7
Install clipnuts on the front columns of the cabinet (see Figure 19). These are
used for the retention bracket screws.
Advertising