HP NonStop G-Series - Manual (Page 193)

Command Interpreter
HP AutoSYNC User’s Guide—522580-015
8-105
SYNCHRONIZE
specifies that the Safeguard ACL for a source Enscribe disk file is not
propagated to the destination when the file is synchronized. A warning is
written to the logfile to notify the user that the Safeguard setting for the source
file has been turned off on the destination.
The default is NO NOSAFEGUARD and the ACL for a source file is
propagated to the synchronized destination file.
RECOVER[Y] | NO RECOVER[Y]
enables or disables the recovery option.
If recovery is enabled, AutoSYNC saves a copy of an existing destination file to
an archive subvolume with the name of the Autosync MapDB before it restores
a later copy of the file. If a failure occurs during the synchronization and the file
is corrupted, the archived copy is recovered and replaces the corrupted file.
This option overrides the global parameter [AUTO]SYNCRECOVER.
By default, recovery is enabled.
RENAMEO[PEN]
specifies that remote unaudited files that are opened for shared READ access
or running object files are to be renamed to allow AutoSYNC to replace them.
The syncuser must have PURGE privileges to the remote file for the RENAME
to succeed.
Both the old and new file names are recorded in an AutoSYNC index file called
AAINDEX, located in the MapDB subvolume.
The renamed files are named AAnnnnnn, where nnnnnn is a sequence
number, and are placed in the same subvolume name as the AutoSYNC
MapDB, in the destination fileset volume. Renamed partitions, alternate
indexes and protection views are named ABnnnnnn, ACnnnnnn, and so on.
RESTORE restore-program
the name of the RESTORE object program to use on the destination system
when a file set is synchronized.
If RESTORE is omitted, $SYSTEM.SYSnn.RESTORE is used.
SECURE “rwep”
Note. If the destination file is audited, AutoSYNC displays a warning message and
the file is not synchronized. An audited file cannot be renamed and AutoSYNC cannot
temporarily unaudit the file to rename it because the file is opened.
Note. A synchronized file, table, index or view may not replace an existing object of a
different type.