HP NonStop G-Series - Manual (Page 32)

Installation
HP AutoSYNC User’s Guide—522580-015
2-6
Start the Monitor Process
tables are created. See Appendix A, Operations and Management , for details on the
additional MapDB tables.
As with the SysDB tables, the MapDB table must be registered in a SQL catalog. By
default, these tables are registered in the same SQL catalog where the SysDB tables
are registered.
Start the Monitor Process
Creating a MapDB automatically starts the AutoSYNC monitor process. The monitor
process is a fault tolerant process-pair, so it should not need to be restarted unless the
system is cold loaded. The standard monitor process name is $ZASY. If, for any
reason, the monitor process is not executing, start it with the following command:
Many of the monitor process parameters may also be specified on this command;
consult the section
START MONITOR on page 8-85 for details.
For example:
AutoSYNC 4? create mapdb;
--- AutoSYNC MapDB table $DATA.ASYMAPDB.SYNCUSER created.
--- Map Database for AutoSYNC created.
--- System Database updated
--- Changes will take effect when the Monitor is restarted.
--- Starting AutoSYNC Monitor $ZASY.
Monitor 1.5.4 - 31JAN2002 -- $ZASY (2,327), started 9/21/00 17:19:05
Backup process $ZASY(1,295), no takeovers
Monitor hometerm: $0
Note. The user id used to create the MapDB and start the monitor process may determine
which users are authorized to configure synchronizations; refer to
Section 4, Scheduled
Synchronization for details on this matter.
START MONITOR;
103> autosync
HP Nonstop(tm) AutoSYNC(tm) Command Interpreter(T2713V01) - System \SYS
Copyright Hewlett-Packard Company 2000-2003
Copyright Carr Scott Software Incorporated 1996-2004
* Error * The monitor process $ZASY is not executing.
* 652 * To start a monitor, issue the START MONITOR command.
AutoSYNC 1? start monitor;
--- Starting Monitor process $ZASY
Monitor 1.6.1 - 14SEP2004 -- $ZASY (4,358), started 6/10/04 15:48:21
Backup process $ZASY (3,366), no takeovers
Monitor hometerm: $0