HP 3PAR Application Software Suite for VMware Licenses - Manual (Page 62)

Viewing Virtual Copy event logs
Virtual Copy operation event logs can be found at the vCenter Server level in the navigation tree,
the Tasks & Events tab, and the Events tab. Use the keyword HP 3PAR to select all events performed
by HP 3PAR Recovery Manager Software for VMware vSphere.
Figure 37 Viewing the Virtual Copy event logs
Creating New Virtual Copies
Prior to creating a Virtual Copies, the following restrictions should be noted:
•
Creating a Virtual Copy at the VM level requires available space on the Datastore where the
VMDK file resides.
•
Datastore creation from NFS drives is not supported from Virtual Copy operations.
•
Recovery Manager for VMware vSphere requires VMFS snapshots. However, taking a VMFS
snapshot of a VM participating in disk sharing, such as Microsoft MSCS, is not supported.
This is a VMFS limitation.
•
The following steps only applies to Virtual Volumes that are not Peer Persistence enabled. If
Transparent Failover is enabled, use the Remote Copy page to create new Virtual Copies. See
“Creating Remote Virtual Copies” (page 84) .
NOTE: Virtual Copy space must be available on the HP 3PAR Virtual Volume. In order to create
a Virtual Copy on an HP 3PAR base volume, the volume must have the Virtual Copy space allocated
during its creation.
To create a new Virtual Copy on the VM or Datastore, perform the following:
1.
Follow the instructions in “Viewing Virtual Copy information” (page 60) .
2. Click the Virtual Copies tab.
3. Click Create. You are then asked to supply the name for the Virtual Copy set.
NOTE: If you do not wish to name the Virtual Copy set, click OK. The created Virtual Copy
is identified by a date and time stamp.
62 Working with Virtual Copies