HP NonStop G-Series - Manual (Page 230)

Backing Up and Restoring Disk Information
Guardian User’s Guide — 425266-001
11 -24
Running Backcopy
source-tape
Name of the tape drive that reads the tape you are duplicating, or a TAPE DEFINE
name.
dest-tape
Name of the tape drive(s) where the duplicate tape(s) is written, or a TAPE DEFINE
name.
*.*.*
Specifies all files on the source tape. You cannot specify individual files.
command-option
A Backcopy command option:
Backcopy copies all files. If Backcopy cannot read a file because of a parity or
checksum error, it displays an error message and the tape duplication fails.
A duplicate tape generated with Backcopy is different from a parallel tape copy
generated with Backup:
•
When parallel copies are made with Backup, both copies contain exactly the same
amount of information on each reel. You mount new tape reels for both copies at the
same time. Backup makes identical copies so that each reel of tape is
interchangeable with its corresponding copy during a Restore.
•
When you make a second copy with Backcopy, the amount of information on each
tape reel can vary between the copies. You mount a new tape whenever a drive
reaches the end of reel; you do not necessarily change tape reels for both copies at
the same time. The individual reels are not interchangeable; only the whole
duplicate tape set is interchangeable with the original set.
Table 11-5. Backcopy Command Options
Option Function
ARCHIVEFORMAT Specifies the archive tape format (tape version 3)
DENSITY Specifies the tape density in bits per inch (bpi)
LISTALL Lists all files copied, including any files that cause errors
NOUNLOADIN Causes the last source tape not to be unloaded
NOUNLOADOUT Causes the last destination tape (or tapes) not to be unloaded
PAGELENGTH Lets users specify between 20 and 100 lines per page to be displayed
on a utility listing (default value is 60)
TAPEMODE Specifies the tape mode for streaming tape drives
VERIFYREEL Makes Backcopy verify each tape reel after the reel is written