HP OmniBook 4150 Notebook PC - Manual (Page 9)

Starting DiagTools
Installing and Setting Up DiagTools
1-3
There are two files available for downloading:
•
The DiagTools utility. A compressed file (with the extension .EXE) which
contains all the files necessary for running DiagTools.
•
The User’s Guide for DiagTools – the document you are reading. It is a PDF file
which can be viewed and printed using Adobe’s Acrobat Reader. (The Adobe
Acrobat Reader can be downloaded free of charge from HP’s World Wide Web
site.)
After you have downloaded the DiagTools file, follow the instructions included with
the file:
Creating the DiagTools Floppy Diskette Locally
Depending on your notebook computer software, you may be able to create the
DiagTools floppy diskette locally. After inserting a formatted floppy diskette in the
floppy drive, do one of the following to create an DiagTools floppy diskette:
•
On an HP notebook computer with a factory software installation, run diaginst
if it is present in the \Dmi\Hpdiags directory on the hard disk. To do this in
Windows, double-click the file.
–or–
For an HP notebook PC with TopTools installed, check whether the DiagTools
tab can create the diskette.
•
On any computer with a CD-ROM drive, run
diaginst if it is present in the
Drivers\Hputils or Dmi\Hpdiags directory on the Recovery CD that came with
the notebook PC. To do this in Windows, double-click the file.